gberns
November 12th, 2007, 08:39 PM
Am running 3.0.563. After reading a thread on the sending of statistical information I went to see how often my program was sending it and realized the program was not running. Tried to start and it would not do so. Did a repair installation and am now doing a manual scan of my drive. The log shows the program started as usual this morning and did a signature update at around 11am Whatever happened took place after that.
When I tried to start the program I got a blank control panel and eventually a message about something being unable to communicate with either the kernel or the service. Should have made a note of this but didn't as was concerned about getting the program up and running again.
Feeling a little concerned about now.
When I tried to start the program I got a blank control panel and eventually a message about something being unable to communicate with either the kernel or the service. Should have made a note of this but didn't as was concerned about getting the program up and running again.
Feeling a little concerned about now.