Cloning SCSI Disk to an Array on a E200 Controller

[kiske]

Hi,

I've an HP Proliant ML350 G5 server, and at this time I've installed only one SCSI 18Gb Disk over an old Adaptec 29160 controller.
In few days I'll get two hotswap disks to connect in the E200 SmartArray controler...
What's the best true image software version to do the clone from the old SCSI disk to the new disk array?

Thank you in advance...

[dja2k]

Try True Image Version 10 but not the new 11. :)

dja2k

[kiske]

"try" means you're not sure? ???

[dja2k]

I mean don't use 11 cause its more likely it will not see your hard drives during the BOOTCD with recent problems it has encountered. Those are old SCSI controllers and I am not sure if they will be seen, but I have used True Image 10 in a lot a computers old and new without problems, so True Image 10 might be your best choice. You can contact Acronis Customer Service or PM the Acrnois Rep around this forum.

dja2k

[kiske]

-{ Quote: "I mean don't use 11 cause its more likely it will not see your hard drives during the BOOTCD with recent problems it has encountered. Those are old SCSI controllers and I am not sure if they will be seen, but I have used True Image 10 in a lot a computers old and new without problems, so True Image 10 might be your best choice. You can contact Acronis Customer Service or PM the Acrnois Rep around this forum.

dja2k" }-

Many thanks!