238drac
July 11th, 2007, 03:09 PM
I am haveing a problem with DD10 recognizing a Seagate Barracuda 80 GB Sata 1.5 Drive.
I think this might be an Acronis issue for the follwing reasons:
1] Every time I open DD10 the sector #'s reported as errors change.
2] Every time I open DD10 the # of bad sectors changes, sometims 3 are bad, sometime 5, sometims 15
3]I can partiton the drive and use it without problems if IGNORE ALL.
4] I have a second drive and it does the same thing.
5] Ironically every bad sector # on disk 1 is reported as a bad sector also on disk 2.
Anyone else have these issues?
I think this might be an Acronis issue for the follwing reasons:
1] Every time I open DD10 the sector #'s reported as errors change.
2] Every time I open DD10 the # of bad sectors changes, sometims 3 are bad, sometime 5, sometims 15
3]I can partiton the drive and use it without problems if IGNORE ALL.
4] I have a second drive and it does the same thing.
5] Ironically every bad sector # on disk 1 is reported as a bad sector also on disk 2.
Anyone else have these issues?