NOD32 for DOS and NTFSPro

[jpmigliozzi]

I am trying to use the NOD32 for DOS version to scan NTFS drives configured for read/write with NTFSforDOS (by Winternals). However when I run NOD32 for DOS its not seeing the NTFS partition. It only picks up the CD Rom and floppy drives. Any thoughts?

Joe

[Jarry]

-{ Quote: "I am trying to use the NOD32 for DOS version to scan NTFS drives configured for read/write with NTFSforDOS (by Winternals). However when I run NOD32 for DOS its not seeing the NTFS partition. It only picks up the CD Rom and floppy drives. Any thoughts?

Joe" }-
Hi!
please check the installation that is NOD 32 for DOS, and ensure that is well and NTFS drives as well.NOD 32 for DOS version has supported NTFS.

[jpmigliozzi]

I should have been more specific. I have built a Boot CD with Nod32 for dos on it. I am using the CD to fix dead systems with virus / spyware infections. My hope is to boot off the CD and then run NOD32 for DOS to clean it. Maybe this is the problem. I don't understand why it can see the floppy and cd rom but not the hard drive partition.

[plantextract]

Sata or Pata drives?

[jpmigliozzi]

PATA but could be SATA. Very strange. Once I load the NTFSPro driver and can do anything to the drive but for some reason NOD32 is not seeing them.

[Jarry]

How is the safe mode, which is with the command?

[jpmigliozzi]

Haven't tried it. Will give it a shot. This may not help me in every situation though, if I don't have the admin password or the system will not boot.