Resize on Restore is not working

[sdrake]

When I restore a 72GB image (XP pro) and select Resize Partitions, the resulting system has Windows in a 72GB partition and the remaining space is unallocated. The resize option was ignored. I tried TI 9 builds 3633 and 3677 - same result. The system restores fine, it just doesn't resize. The log has no errors.
Running /bin/sysinfo when booted from TI, shows:
md driver 0.90.0 loads
Autodetects RAID arrays, then...
md: could not read cciss0/disc0/disc's sb, not importing!
md: could not read cciss0/c0d1, zero-size? marking faulty
md: could not read cciss0/c0d2, zero-size? marking faulty
etc...

The file /proc/driver/cciss/cciss0 shows: cciss/c0d0: 139.94GB RAID 0"

At the end of the output from /bin/lspci, the loaded modules are listed and does not include cciss.

Does this mean TI is unable to correctly detect my HP P400 Smartarray RAID controller and my logical drives (cciss/c0d0, cciss/c0d1, cciss/c0d2)?
My hardware is HP Proliant ML370-G5 with P400 Raid controller and SAS hard drives (2x72GB). How do I get resize to work?
Thank you,
Steve

[jmk94903]

-{ Quote: "When I restore a 72GB image (XP pro) and select Resize Partitions, the resulting system has Windows in a 72GB partition and the remaining space is unallocated. The resize option was ignored. " }-Did you check the box to restore the entire hard drive or just the box to restore a particualar partition? I've seen that the size can't be adjusted if you check the entire disk box instead of just the partition.