PDA

View Full Version : Network monitor problem

Vasya4
February 1st, 2006, 10:11 AM
I have strange problem with network monitors. I tried to use Commview and NetPeeker. As soon as network drivers for any of them installed I lose any connectivity. I still get an IP address, DNS, etc. but none of the programs are able to go online.

However, it gets back to normal when I disable Internet Filtering in Look'N'Stop. I use L'N'S v2.05p3 with advanced ruleset.

Any Ideas?

Thanks!
Frederic
February 11th, 2006, 12:50 PM
Hi,

Is there any alert in the Look 'n' Stop log when this happens ?

Frederic
Vasya4
February 25th, 2006, 05:08 PM
No, there is no alert. Otherwise I would be able to figure it out myself. :'(
Frederic
February 26th, 2006, 12:52 PM
In the advanced options, if you have enabled the protocol verification, then maybe one protocol has been installed and is used by one of the applications you have mentioned, and this protocol has been blocked. Open the protocol configuration box to check that.

Otherwise, one rule is blocking the packets, and the log is disabled for that rule (no ! for that rule). You should then try to enable the ! for the blocking rule and see which one is blocking packets.

Frederic