PDA

View Full Version : PG3.2 & Small Issue with Human Confirmation


Baldrick
December 23rd, 2005, 04:22 PM
Hi there

Just downloaded and install PG3.2 and all is well.......except what I think is a small problem with the button displayed on the Human Confirmation Required panel.

Have protected the closing of PG so that Human Confirmation is required. Panel comes up when you try to close PG and you can enter the code displayed but the button either side of the entry field are there (Red on the left and Black on the right but with no text in them so if you do not know that the one of the left is 'OK' and that on the right is 'Cancel' then you are stuffed/have to resort to trial and error).

Having played around with the buttons I actually managed to get PG to close despite Secure Message Handling set to required (as set against processguard.exe in the Protection tab) but after I restarted PG the Human Confirmation Require panel was again displayed when I tried to close PG.

Hum........something not quite right in there some where.

Hope that this information helps? Apart from that PG seems to be even better than before. The best just got better. Not often you can say that, eh?

Best regards




Baldrick

Baldrick
December 26th, 2005, 09:29 AM
Merry Christmas to all

Am I the only one out there with PG 3.2 installed who is experiencing this issue?

Hopefully there will be a fix for this sometime soon?

Regards



Baldrick

FirePost
December 26th, 2005, 04:31 PM
-{ Quote: "Merry Christmas to all

Am I the only one out there with PG 3.2 installed who is experiencing this issue?

" }-No you are not the only one.. I installed 3.2 and see the same thing.

siliconman01
December 28th, 2005, 07:02 AM
Running Windows XP-SP2 HE, ClearType active with screen resolution 1024x768.

Am seeing a similar problem except I only get the center window for inputting the code. Then I get a THANK YOU and no windows to confirm closure.